I've got to step 8 in building my Blues OverDrive pedal wher. it says:
Code:
Add wires to the IN, OUT, LED, POS, and the Ground eyelet located in the top of the board. Start by cutting 4 3.5" pieces of wire...
And then it goes on to show a picture of the board with seven different pieces of wire sticking out of the board.
I don't see any obvious reasons why it should say to start with cutting four wires instead of seven. If only four, which holes do these so in, out of the seven. Is there just a typo in the instructions? I just want to make sure I'm not misunderstanding something.