Build Your Own Clone Message Board

Can I use this to replace the 24 AWG wire that comes with the kits? I like the idea of colour coding the various wires… or should I stock up on more 24? I recently bought some 22 gauge out of the excitement of my new hobby, as it didn’t cost much I’m good with shelving it for now. At this point I still have much to learn about signal, current etc.


Sent from my iPhone using Tapatalk

Sure, 22 gauge should work fine for pedal builds. Assume that it's stranded wire?

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

Yes, stranded. Thank you. Just finishing up my fuzzes. On a side note, not that it matters much but the checklist for components that I printed off from the “build instructions “ are slightly mis-titled. The list is accurate, that’s all that matters.



Sent from my iPhone using Tapatalk

Thanks. I let Keith know about the error.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2