bsport wrote:
Where are the Classic Overdrive's 100 and 10K resistors that make it an 808 vs. a TS9?
R15 (100R) and R16 (10K) on the labeled PCB diagram following:
bsport wrote:
Also, how do I wire the toggle switch? I'm assuming I just need a mini on-on switch. Wire the 4 resistors to the toggle and then the toggle to the pads?
For better long-term reliability, I would suggest using a
4PDT toggle switch, which will allow you to solder the switched resistors across the pairs of adjacent throws. This avoids "hanging" resistors off the switch, which can result in broken leads through handling & use over time. Wire it as shown below; I'll leave the challenge of deciding the best way to mount the switch up to you. Personally, I'd have the toggle bat coming out of the side of the enclosure.
Attachment:
4PDT_toggle_resistor_switch.gif [ 4.04 KiB | Viewed 3664 times ]
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2