Build Your Own Clone Message Board

It is currently Tue Oct 16, 2018 12:17 pm

All times are UTC - 6 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Jun 22, 2018 8:00 pm 
Offline

Joined: Mon Mar 26, 2018 12:42 pm
Posts: 91
I believe that I have a solder bridge between Q1 and Q2 it looks like they are connected in the schematic, will this cause an issue? The pins are so close together for some reason I cannot seem to get rid of all of the solder.


Top
 Profile  
 
PostPosted: Sat Jun 23, 2018 4:00 am 
Offline
Moderator
User avatar

Joined: Sat Mar 04, 2006 9:15 pm
Posts: 7402
Location: Ohio
Take a look at the schematic on page 30 of the build guide. In the upper right corner you can see that the Collectors of Q1 & Q2 are connected directly to each other. Your solder bridge is not an issue.

It’s a good idea to have a magnifying glass handy when you assemble a PCB. This will allow you to inspect solder pads that are located right next to each other to see if they are connected by a trace on the PCB.

_________________
"It’s your soldering."

If Gene Roddenberry were alive today I would punch him in the face.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group