Build Your Own Clone Message Board

Don't use this pedal much, so just noticed now...the decay control appears to be set at FULL, no matter what position I put the pot in. I have 3.2 volts on 2 of the pot pins, no matter what position the pot is in...Any ideas where to start tracing this? Thanks

1st thing is to pull out the pcb and inspect and reflow the solder joints on all the wire connections on the pot and the pcb. Make sure there is no bare wire touching anything it shouldn't.

_________________
MasterDelayer/Reverbrador/Ampaholic/TopJacker

Yep, did all that...twice...even had the pcb board out of enclosure and fired it up....I just can't tell from the schematic which pot point(1,2,or 3) is supposed to be wired to ground...