Build Your Own Clone Message Board • View topic

View unanswered posts | View active topics

Board index » Build Your Own Clone » Effects Pedal Technical Support » BBD effects, Delay & Reverb

All times are UTC - 6 hours

Analog Chorus

Moderators: geekmacdaddy, sjaustin, Non-Reverse, duhvoodooman, Stephen, Morgan, Matt, ParanoidAndroid

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Author

Message

jonnytexas

Post subject: Analog Chorus

Posted: Tue Dec 15, 2020 6:18 pm

Joined: Mon May 18, 2020 11:31 pm
Posts: 57

I had one of the versions that needed the 56k resistor tacked across the IC. I did that, and it choruses now when I turn the rate knob back and forth manually. The LED is not changing with the rate knob. It just stays on or off like a regular indicator LED. Before I post a picture, should I just try a new TL022?

Top

Morgan

Post subject: Re: Analog Chorus

Posted: Tue Dec 15, 2020 7:11 pm

Moderator

Joined: Wed Apr 26, 2006 5:14 pm
Posts: 8659
Location: Truckee, CA

Modern op amps are rarely bad. It's much more likely that you have a bad connection or solder joint in the LFO section of the circuit. You can also replace the TL022 with any typical 8-pin dual opamp if you have any in another build.

_________________
MasterDelayer/Reverbrador/Ampaholic/TopJacker

Top

Page 1 of 1

[ 2 posts ]

Board index » Build Your Own Clone » Effects Pedal Technical Support » BBD effects, Delay & Reverb

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: