Build Your Own Clone Message Board

Hey guys,

I'm working on my first ever build or working on any electronics but it seems like the last resistor I have doesn't match the color mentioned in the instruction guide.

Based on http://byocelectronics.com/lilreverbinstructions.pdf:
Resistors
1 - 100 Ohm/101 (Black/Brown/Black/Black/Brown)
4 - 1k/102 (Brown/Black/Black/Brown/Brown)
1 - 4k7 /472 (Yellow/Purple/Black/Brown/Brown)
2 - 6k8/682 (Blue/Gray/Black/Brown/Brown)
3 - 10k/103 (Brown/Black/Black/Red/Brown)
7 - 22k/223 (Red/Red/Black/Red/Brown)
3 - 33k/333 (Orange/Orange/Black/Red/Brown)
3 - 100k/104 (Brown/Black/Black/Orange/Brown)
1 - 470k/474 (Yellow/Purple/Black/Orange/Brown)

The one I'm missing is in bold (1 - 100 Ohm/101 (Black/Brown/Black/Black/Brown)). I have the rest already matched up. I instead have a Brown/Black/Black/Black/Brown (order doesn't match). Will this affect anything if I were to install this resistor on the board?

Thanks!

You have the 100 ohm resistor, which is the brown/black/black/black/brown one you described. The parts list evidently contains a misprint. Interestingly, nobody has previously pointed out that typo, so thanks for that! I'll let Keith know so that it can be corrected.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2