First time builder here. I am working on building the Classic Delay kit. I got a splash of solder on the PCB, and while trying to remove it, I managed to strip off the solder pad...
It's pretty obvious in the pictures, especially in the picture from the back, the one marked "7" which will eventually connect to lug #7 of the footswitch. I am pretty sure the solder pad I ripped off is still in the through hole. I think I will still be able to get a wire in there, but wanted to be sure I didn't ruin something worse. Can anyone help me figure out where I should place the leads to test for continuity? I am guessing it could still be ok, but would rather check it out now than have an issue to troubleshoot later.
Also now that I am looking, some of those joints don't look like they have much solder, am I adding enough?
Thank you!