Build Your Own Clone Message Board

So here are all the pics i did resolder twice so maybe i damaged a component or i put it in backwards?
also i thought it might be the trim pot so i replaced it with one i picked up from an electronics store... still 10k
And the black marks on the bottom are from when i started to mark which solders i had re done

and again i checked every soler with a digital multi meter and everything check out good

The PCB does look somewhat better; however, you still have a few blobby joints and there is a LOT of splatter - so much so that I believe you probably have several shorts. Take a wooden chopstick or match and rub those splatters off, carefully, especially the ones that cross traces. Also, you need to clip a couple of those leads that are sticking out. Try that and report back symptoms.

so still nothing it seems no that i clipped the leads and re did a few more solders the volume is a little bit higher.... but still the trim pot nor the sensitivity or the attack knob hav any affect on the tone colume or volume swell. Also i went through and made sure none of the compnonents were switched. Any other advice or should i just move on

so i made a tester today and i traced it back to c4. it was the last one that didnt work. Which ever one was next had signal

i traced back from the outr

????? anyone

I would try replacing c4. I'm away from my machine so I can't check if that cap is polar - it is you could have it in backwards - check that before replacing.

*EDIT - c4 is polar

ya im pretty sure it was in the right way but i took it out and radio shack didnt have the right one so im heading over to another place tomorrow... ill keep you updated.

Thanks so much for all the help!

so i replaced it but they only had a 100v and no the 25v but i dont think going up in rating is a problem... so once again im stuck

........