byoc wrote:
In my experience, the most common problem that happens when you rehouse a pedal is one or more of the wires becomes frayed or pulls loose from its solder joint. Try giving all the wires a good tug to see if anything lets go.
OK... walked through the whole thing. Re-flowed joints that I could reach easily, checked for shorts, and re-flowed each of the wire endings (jack lugs, PCB pads, DC jack, 3pdt poles, etc.). Checked for continuity here and there looking for an obvious problem. Pulled and reseated the ICs.
Still broke. Bypass works, but the PCB does not pass a signal. The LED lights.
Does anyone have voltages at key points that I can check for? I don't know the circuit so I'm not sure how to follow it or what to expect from it. Also would like to know how to test the two ICs (or at least check for voltage on pin 1 and the out pins). The schematic is included in the instructions, so I'll print it out and start to try to map it to the PCB.
Thanks for any help. Hate for this thing to become a doorstop.