OK, I can see where you've switched around three resistors. Refer to labeled PCB diagram below for locations:
- R3 is a 4K7 (472) and should be a 470K (474)
- R9 is a 470R (471) and should be a 4K7 (472)
- R19 is a 470K (474) and should be a 470R (471)
I would also double-check the areas between the IC legs that I've circled in the marked-up section of your photo attached below. Just make sure there's no bridging or other material connecting those adjacent legs.
Attachment:
check_for_bridging.jpg [ 28.71 KiB | Viewed 2225 times ]
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2