Build Your Own Clone Message Board

Has anymore had luck with fitting a replacement PC-mount trimpot?
I was over-zealously adjusting the level trim on my finished Brown Face, while energized , and zip, burn
I'm super close to Digikey and will at some point just take a gamble on one that looks like it will fit the holes, but thought it's worth asking.
When I find the right one I'll update, I'm maybe not the only one.
Thanks,

I use the 3362P series trimmers, which are like 7mm square. I forget the part designation for the 10mm square ones off hand. The 'P' indicates the pin orientation.

https://www.bourns.com/docs/Product-Datasheets/3362.pdf

Take a look at the data sheet and compare the measurements to your hole orientation. You'll see what the letters represent as they are all laid out on the sheet.

https://www.digikey.com/products/en?keywords=3362P-1-104LF&v=118

_________________
If practice makes perfect, and nobody is perfect, then why practice?

It hurts me to say this.. but.. follow me on facebook and.. instagram

I've had excellent luck with parts & components from Tayda:

https://www.taydaelectronics.com/potent ... r-6mm.html

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2