Build Your Own Clone Message Board

It is currently Fri Mar 29, 2024 1:13 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Jan 14, 2017 10:07 am 
Offline

Joined: Sat Jan 14, 2017 9:51 am
Posts: 1
I have a fair amount of trouble shooting to do, as my pedal was not powering on when I completed my build. I started working on it but my de-soldering skills are still woeful. In attempting to address some potential problems I ripped/marred a few of the eyelets on my pcb. I'm assuming I need to replace these in order to establish good connections. If these are replaceable, what dimensions should I be looking for? If not, how should I proceed?


Top
 Profile  
 
PostPosted: Tue Jan 17, 2017 1:55 pm 
Offline
Site Admin
User avatar

Joined: Sun Jan 22, 2006 1:39 pm
Posts: 5984
Location: Richland, WA
Oh boy....

You'll probably be ok with the negative power eyelet since you ripped out the top solder pad and the trace is connected to the bottom. Just make sure you solder on the bottom side of the PCB.

That footswitch is another story. You've disconnected the trace from the solder pad. You could use a piece of wire to make a jumper between lug 2 of the volume pot and the top of the eyelet that you ripped out.

_________________
*patience is a virtue*

Please do not PM me. email is prefered. keith@buildyourownclone.com


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group