jedisir wrote:
...I am assuming this would point towards the input and out put jacks/wiring/soldering correct?
Correct. Start your troubleshooting by carefully inspecting the I/O jack wiring, including the wire connections to the PCB. In particular, check to be sure that you've used the correct solder tabs (tip for signal, sleeve for ground) and that your solder joints look good.
Would definitely help to see some photos....
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2