Build Your Own Clone Message Board • View topic

View unanswered posts | View active topics

Board index » Build Your Own Clone » Effects Pedal Technical Support » Wah, EQ & Octave

All times are UTC - 6 hours

Wah pot cog and gear fit

Moderators: geekmacdaddy, sjaustin, Non-Reverse, duhvoodooman, Stephen, Morgan, Matt

Page 1 of 1

[ 4 posts ]

Previous topic | Next topic

Author

Message

mtlin

Post subject: Wah pot cog and gear fit

Posted: Sat Oct 21, 2006 5:51 pm

Joined: Thu Jan 26, 2006 9:51 am
Posts: 20
Location: Toronto

What is the best wah of fitting the cog on the pot with the straight geared piece? Depending on where you put it, I assume, you will get different frequency response. What is the stock setting? Dead in the middle of the pot's range? I hope my question is clear.

Best,

Martin

Top

Stephen

Post subject:

Posted: Sat Oct 21, 2006 6:46 pm

Moderator

Joined: Sat Mar 04, 2006 9:15 pm
Posts: 7662
Location: Ohio

Set it at about the middle of it's rotation and then fine tune it one way or the other 1 tooth at a time. Do this until you find your pot's sweet spot.

Top

mtlin

Post subject:

Posted: Sat Oct 21, 2006 11:05 pm

Joined: Thu Jan 26, 2006 9:51 am
Posts: 20
Location: Toronto

Thanks! --M

Top

Limestone

Post subject:

Posted: Sun Oct 22, 2006 2:56 am

Joined: Thu Sep 28, 2006 10:01 am
Posts: 4

Did you get your kit to fit the dunlop chassis? I have an old dunlop from 90 that i would like to mod.

Top

Page 1 of 1

[ 4 posts ]

Board index » Build Your Own Clone » Effects Pedal Technical Support » Wah, EQ & Octave

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: