Build Your Own Clone Message Board

Is there a way that the buffer in the Wah could be bypassed using jumpers internally rather than an externally mounted switch? (using sockets in the appropriate circuit points. Could this also be done with the second inductor?

After intense investigation, I wonder if someone can confirm if this will work. To allow for two inductors in the simplest manner (without the large 3 pole switch), would leaving out the zero Ohm resistor (above PCB points A,B,C,D) and then jumpering A-D allow for Inductor #1 only. LIkewise, jumpering points B-C for Inductor #2 only ??

For Buffer bypass, leaving out the two right side PCB zero Ohm resistors and jumpering point W-X for buffer bypass, and jumpering points W-Y and X-Z for buffered output. ??

anyone ?