Build Your Own Clone Message Board

Could someone confirm if this will work. To check the differences between two inductors in the simplest manner (without using a large 3 pole switch), would leaving out the zero Ohm resistor (above PCB points A,B,C,D) and then jumpering A-D allow for Inductor #1 only. LIkewise, jumpering points B-C for Inductor #2 only ??

For Buffer bypass, leaving out the two right side PCB zero Ohm resistors and jumpering point W-X for buffer bypass, and jumpering points W-Y and X-Z for buffered output. ??

Do as the instructions say to just use inductor #1, i.e., add the 0 ohm resistor and inductor #1. Remove the 0 ohm resistor and jumper between A and D to use inductor #2.

It's bufferd output, not buffered bypass. Do as the instructions say to just use buffered output, i.e., add the two 0 ohm resistors. Remove the two 0 ohm resistors and jumper between W and X for unbuffered output.

_________________
*patience is a virtue*

Please do not PM me. email is prefered. keith@buildyourownclone.com