You won't be happy to hear this, but there's no need to remove the bridge between D2 and D3 because those eyelets on the PCB are already connected. When two eyelets are located that close together on a BYOC board, it's almost a certainty that they're connected--that's just a matter of sound PCB design. A redundant connection via solder bridge has no effect.
There's a lot more details about this--and how to check & confirm it--in
THIS STICKY POST.
Is the lifted solder pad on the component or solder side of the PCB?
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2