just finished building the swede.
what works:
- the led
- bypass mode
what's happening:
- when circuit is engaged, i'm not getting any sound except for a very, very faint clicking sound
i've checked:
- the orientation and values of the diodes and the electrolytic caps
- the values of the resistors
- the orientation of the transitions and the ICs
- the jack wiring (checked continuity of each connection from jacks to board)
- the footswitch wiring (checked continuity of each connection from lugs to board)
i'm wondering about some very close solder points on the board. wondering if they're shorts or supposed to have continuity. i've circled them in the solder side picture. the lowest pair (diagonal) i scraped to break the continuity:
Attachment:
Swede_solderSide.jpg [ 982.54 KiB | Viewed 3872 times ]
here's the component side:
Attachment:
Swede_componentSide.jpg [ 758.76 KiB | Viewed 3872 times ]
here are the jacks:
Attachment:
Swede_jacks.jpg [ 666.27 KiB | Viewed 3872 times ]
any help is very much appreciated!!
-j