Yes, those circled joints are for a pair of clipping diodes that are already connected on the PCB, so a solder bridge there is of no concern.
There are several analogous pairs of adjacent joints on the CJ PCB because it contains multiple clipping diode arrays. You can determine these by comparing the labeled CJ PCB diagram
HERE to the circuit schematic immediately below it. In this present case, you were inquiring about diodes D12 and D13.
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2