Attachment:
File comment: bottom of pods and top of secondary pcb should this be making connection or not?
jpeg pods.jpg [ 134.5 KiB | Viewed 260 times ]
I have made few mistakes on the way of building and damaged the board. I traced the line and connected the line where I think supposed to be connected.
I am amateur reading the diagram and trying to understand how to test and trouble shoot. In the past I have build many pedal from this cite and I was successful so I though this one is easy to build but I need help.
Two obvious mistakes I have made.
2 places I have made mistakes and attempted to jump by wiring are
1. B 100 KDG Gain A 1 on main board (jumped to connect with resistor 152 (1K5 ohm) on the main board).
2. Jumped resistor 473 (47K) and negative of 1 uf aluminum electrolytic.
Another question is when I installed secondary PCB I wonder whether the bottom of two B10K potentialtiometers touches the top of the secondary PCB to make connection by design?
Initially I put plastic tape in order to avoid any shorts then I got no sound.
When I took of the plastic tape and made intentional connection there, I got some noise which changes when I turn volume, treble and Gain nob. I am guessing that part should be connected by the design since I got some sound there.
I could be wrong about this.
I hope to be able to use this pedal for my upcoming gig on next Saturday,
Appreciate very much for help.
Thanks
Keita