Build Your Own Clone Message Board

It is currently Sat Nov 02, 2024 5:34 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Fri Dec 24, 2021 11:25 pm 
Offline

Joined: Fri Dec 24, 2021 10:47 pm
Posts: 2
Hi yall got a problem im trying to solve and cuious if anyone has any ideas?
Built a Large Beave (rev 2) maybe 4-5 years ago and had no problems. I love this thing and its been a staple of my pedal chain.
Unfortunately a few years ago it got smashed up a bit and the rotary knob got messed up. The bearings are all loose and it dosent click in place anymore it just roll from pos 1 to pos 4 with lots of dead stops btw each setting.

I tried to take it off, but with all those solder points connecting it to the pcb it just wasnt happening.

I really mostly use pos 3 ( mid bump), so i have been trying to figure out a way to some how hardwire that setting. Permanently selecting c10 and c7 as hpf and lpf respectively. I know it is a3 b7 c10 on the rotary knob, but i am still learing about signal path etc and just not sure where to make the jumps?
It seems like it should be fairly simple, but I am not sure exactly what route to go.

Any advice/help would be much appreciated.

Thank you kindly!


Top
 Profile  
 
PostPosted: Sat Dec 25, 2021 10:41 am 
Offline
Moderator
User avatar

Joined: Tue Jan 02, 2007 1:24 pm
Posts: 16287
Location: Albany, NY
You should find this post quite helpful in understanding the signal path through that rotary switch in the LB 2.0: viewtopic.php?p=150760#p150760

That said, it would still be highly advisable to remove that switch so that you don't have the possibility of parallel signal paths between your "hard-wired" path and the switch connections, since it sounds like there may still be some functionality there. Having done this myself (one the old BYOC Tri-Boost, which used the same 3P4T rotary) I can tell you that it's very doable with a combination of patience and the right tools, specifically a "solder sucker" and some good quality desoldering braid. You just have to be careful not to force anything, because that's how you tear up the eyelets and traces on the PCB and create more problems for yourself.

Replacement switches are available from Mouser: https://www.mouser.com/ProductDetail/E- ... zjJw%3D%3D

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2


Top
 Profile  
 
PostPosted: Sat Dec 25, 2021 10:15 pm 
Offline

Joined: Fri Dec 24, 2021 10:47 pm
Posts: 2
Thanks a bunch for that advice. I think I have been avoiding it as an option, but your right, the best thing to do would just be to get the right tools and get aquianted with the desoldering process.
Appreciate it!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group