Build Your Own Clone Message Board

In reviewing the instructions and schematic for the Green Pony, it appears there is a discrepancy. I was shipped and the instruction parts list both show 2 LEDs, but the schematic and the PCB both indicate 3 LEDs. There is only 1 hole in the enclosure for an LED. I believe I need 3 LEDs for this build. Can someone confirm I am correct?

Thanks,
Ed

Yes, you should have 3 LED's in the kit--two for signal clipping that are installed side-by-side on the PCB and one that shows through the hole in the enclosure and indicates if the effect is engaged (LED on) or bypassed (LED off) with the footswitch.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

Thank you again. In reviewing my parts again, I did find the indicator LED in another bag, so all is good.
Thank you for your quick help,
Ed