Build Your Own Clone Message Board

It is currently Tue Dec 06, 2022 7:05 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Green Pony LEDs, 2 or 3?
PostPosted: Sat Sep 17, 2022 8:16 pm 
Offline

Joined: Fri Nov 20, 2020 1:15 pm
Posts: 24
In reviewing the instructions and schematic for the Green Pony, it appears there is a discrepancy. I was shipped and the instruction parts list both show 2 LEDs, but the schematic and the PCB both indicate 3 LEDs. There is only 1 hole in the enclosure for an LED. I believe I need 3 LEDs for this build. Can someone confirm I am correct?

Thanks,
Ed


Top
 Profile  
 
PostPosted: Sat Sep 17, 2022 8:46 pm 
Offline
Moderator
User avatar

Joined: Tue Jan 02, 2007 1:24 pm
Posts: 15730
Location: Albany, NY
Yes, you should have 3 LED's in the kit--two for signal clipping that are installed side-by-side on the PCB and one that shows through the hole in the enclosure and indicates if the effect is engaged (LED on) or bypassed (LED off) with the footswitch.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2


Top
 Profile  
 
PostPosted: Sat Sep 17, 2022 9:47 pm 
Offline

Joined: Fri Nov 20, 2020 1:15 pm
Posts: 24
Thank you again. In reviewing my parts again, I did find the indicator LED in another bag, so all is good.
Thank you for your quick help,
Ed


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group