Build Your Own Clone Message Board

On rev 1.2 board, could you please draw a line to each C or R reference component? I am having a hard time with the 510k resistors and c 224 components.

_________________
I see dead people!

Refer to the following PCB map (from THIS THREAD) for the component labeling; though this map was done for the Rev.1.0 board, the components are still in the same basic locations. The main difference is that C5 & C6 were originally tantalum caps and were shown with circular shapes on the silkscreen. They have been replaced with film caps on the Rev.1.2 board, now shown with rectangles with the corners cut off, but in the same two places.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

Thank you very much

_________________
I see dead people!