Build Your Own Clone Message Board
http://byocelectronics.com/board/

Super8 Looper question
http://byocelectronics.com/board/viewtopic.php?f=52&t=54650		 Page 1 of 1
Author:  monkthecat [ Mon Feb 27, 2017 6:07 pm ]
Post subject:  Super8 Looper question
Hey all:

Getting close to the end of the build on my Super8 Looper, and have a question about the IC orientation. Page 25 of the PDF instructions say "don’t forget to orient the ICs so the end with the notch matches up with the end of the socket that has a notch as well."

The big IC has a notch but the big IC socket does not; and the small IC has no notch but small IC socket does. As a result, I'm not sure how to orient either one (see attached pics).

Can anyone help?

Attachment:
File comment: Small Socket
Small Socket.JPG
Small Socket.JPG [ 78.54 KiB | Viewed 3312 times ]

Attachment:
File comment: Large socket (no notch)
Large Socket.JPG
Large Socket.JPG [ 410.97 KiB | Viewed 3312 times ]

Attachment:
File comment: Two circuits
Circuits.JPG
Circuits.JPG [ 230.77 KiB | Viewed 3312 times ]
Author:  Nwkenning [ Mon Feb 27, 2017 6:46 pm ]
Post subject:  Re: Super8 Looper question
monkthecat wrote:
...



The big socket has a notch right at the '40' on the socket, and on the small IC, the dot represents pin1, so that end would be the notched end.
Author:  monkthecat [ Mon Feb 27, 2017 6:47 pm ]
Post subject:  Re: Super8 Looper question
Thanks!
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/