Michael UK wrote:
Thanks for the quick response.
When its in loop mode, and turn loop 1 on and off (by pressing BP and 2 simultaneously), the voltage at pin 26 stays at zero volts. I can't get loop 1 to activate at all.
Each time BP and 2 are pressed simultaneously the bank LEDs go through the following cycle:
- all lit
- B & C lit, A unlit
- A & B lit, C unlit
- A & C lit, B unlit
- C lit, A & B unlit
- B lit, A & C unlit
- A lit, B & C unlit
- all lit etc.
From my understanding there are four states above that shouldn't be possible??
When 2, 6, 8 are pressed simultaneously the above process runs in reverse.
I've not tested a guitar signal through it yet but the other loops appear to be working fine. It also appears to be letting me store presets in PRESET MODE even in the 'additional' banks.
Thanks
That's very weird. A malfunctioning chip is the only thing I can think of to explain that behavior. Please contact
sales@buildyourownclone.com for a replacement.
_________________
*patience is a virtue*
Please do not PM me. email is prefered.
keith@buildyourownclone.com