byoc wrote:
I'm really sorry about that. I see that the holes aren't lining up. But was the initial problem that you couldn't get the PCB into the enclosure? Were the screw hole ribs in the way?
My panties aren't in a bunch - I realize we all make errors & that we try our best. I'm just thankful that you've made it possible to buy high-quality items that sound great at a fraction of the price of other pedals which, often have less flexibility than byoc comparable items.
I can get the PCB into the enclosure no problem but, not thru the holes. I can line up one hole on the edge, however; the opposite side is impossible to line up because the PCB is stopped by the enclosure. even if I grind the PCB down, the jack housing would end up hitting the enclosure. PCB is rev1.2. All in all - the holes are spaces too close.
tested build with success - never soldered LED's as this was the final step.
got this from the CA distributor as it was out of stock on USA site.