Build Your Own Clone Message Board

It is currently Thu Mar 28, 2024 2:37 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Nov 25, 2021 3:17 am 
Offline

Joined: Tue Oct 25, 2016 8:36 pm
Posts: 6
I'm trying to do a power analysis on my target, which runs on 3.3 volts. Without the resistor, the average current while running is roughly 140mA.
I used a 10 Ohm resistor a shunt resistor with a 5V power source. The voltage difference between VCC PIN and GND was measured using a shunt resistor linked between 5V and the target VCC pin. (The decoupling capacitors have been removed.) On the other hand, the oscilloscope lacked a proper power consumption line.
Is there a problem with my setup? Is there any guidance on how to choose a shunt resistor?
Thank you so much for your assistance!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group