Build Your Own Clone Message Board

Here's a Clari(not) stripboard build I put together recently (forgot to snap an inside pic once again )





It's a vero board, and it has one small problem..
if I tighten down the backplate, it stops working.

(it's a little cramped in there) I will solve this, but until I figure what's grounding out, I'm enjoying it with the back off..

_________________
EricBarao.com | Facebook Artist Page

OTRFX Website | OTRFX on Facebook
________________________________________________________

Cool!

Where'd you get the giant "Keith" knob??

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

I have to assume I found it in the drawers at Rat Shack.. it's definitely something that's been hanging around for quite a while. The other one I had was used for my Imperial Sagulator (voltage sag box):

_________________
EricBarao.com | Facebook Artist Page

OTRFX Website | OTRFX on Facebook
________________________________________________________

Love the way you laid it out. Fun pedal. Kinda.

_________________
Everyone likes sausage. Nobody wants to see how it's made.

right? I fool around with it for a while, I love it's weirdness, but it's too weird for my pedalboard.. then I sell it and immediately miss it and next thing you know, I've built another one.

_________________
EricBarao.com | Facebook Artist Page

OTRFX Website | OTRFX on Facebook
________________________________________________________