Build Your Own Clone Message Board

Finished my Crowm Jewel Kit. JFET boost.

That doesn't sound right. Either of the hard clip settings should give a very noticeably more distorted, "hairy" sounding tone than the soft settings. This is most notable when running one type OR the other. If you have both turned on, you'll get something in between.

If neither of the two hard clip settings seems to work, I would check the function of the hard clip toggle switch, since that controls both settings. If one side of the toggle sounds distorted and the other side doesn't, it could be either the switch or the diode pair on that side.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

I heated up the solder joints and its all good now. Thank you.

Looks good. You could shorten up those footswitch wires. Won't improve anything in terms of noise because signal doesn't travel through those wires. They just short to ground when you step on the switch. It will just look cleaner.

_________________
*patience is a virtue*

Please do not PM me. email is prefered. keith@buildyourownclone.com

Who are you to tell me to shorten the wires? The instructions said 3 inches! Oh, wait. Yes, sir.