OK, the image below shows how I'd wire it up. The I/O and DC jacks should be wired to the top of the main PCB per the Green Pony's instructions. Rather than running a wire all the way from the DC jack to one of the +9V eyelets on the 3PDT board, I'd use the top lead of the 1N4001 diode at the lower left of the main PCB for the power connection (red wire on my diagram).
Two options on the LED installation:
- If you're using the LED installation on the 3PDT mini-board, leave out the wire shown in green and install the CLR and LED on the mini-board per the GuitarPCB instructions.
- If you use the LED installation on the BYOC main PCB, then leave out the CLR and LED on the mini-board and run that green wire from the left-most D1 eyelet to eyelet 1 on the main board.
Attachment:
3PDT_miniPCB_hookup.jpg [ 120.97 KiB | Viewed 1086 times ]
_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)
My Website *
My Musical Gear * My DIY Pedals:
Pg.1 -
Pg.2